TPMS Reset Tool Tire Pressure Monitor Sensor Relearn For Ford F150 Edge Mustang

Description

TPMS19 Training Program Tool is a direct fit for the following: 2007-2016 Ford F-150 2008-2016 Ford F-250 F-350 F-450 F-550 Super Duty 2010-2016 Ford Mustang 2007-2014 Ford Edge 2006-2016 Ford Escape 2008-2016 Ford Expedition 2006-2016 Ford Explorer 2008-2015 Ford Flex 2008-2016 Ford Taurus 2008-2016 Ford E-150 E-250 E-350 E-450 Econoline Vans 2008-2016 Ford Fiesta 2008-2016 Ford Focus 2008-2016 Ford Fusion 2008-2011 Ford Crown Victoria 2011-2016 Ford Transit Connect 2006-2011 Ford Ranger 2007-2016 Lincoln MKX 2007-2016 Lincoln MKT 2008-2016 Lincoln MKZ 2008-2016 Lincoln MKS 2008-2016 Lincoln Navigator 2008-2011 Lincoln Town Car 2007-2008 Lincoln Mark LT 2006-2010 Mercury Mountaineer 2006-2010 Mercury Monterey 2006-2011 Mercury Mariner 2006-2011 Mercuy Grand Marquis 2006-2011 Mercury Milan
TPMS19 TPMS Reset Tool For FORD F-150 EDGE MUSTANG Tire Pressure Sensor Training
Ford TPMS19 TPMS Reset Tool Tire Pressure Sensor Training Activation Transmitter
TPMS19 TPMS Activation Tool For Ford
Before do TPMS reset, please make sure the car already coding and enable the TPMS function, this is very important. You can use Forscan software with ELM327 to enable the function or use VCMII hardware to enable as well.
Description:
●Tire Pressure Monitoring Sensor TPMS fits for Ford
●Interchange Part Number:TPMS-19, 8C2T-1A203-AB
●Replaces your old and damaged one.
●Placement on Vehicle:Left, Right, Front, Rear
Description:
Ford cars and trucks need to have their Tire Pressure Monitoring System sensors re-trained or activated after the installation of new wheels and tires or after a tire rotation.
Following these simple steps anyone can re-train their TPMS sensors and save themselves a costly trip to the dealership.
Ford cars and trucks newer than 2007 commonly use TPMS sensors that monitor the air pressure in the wheels.
The sensors each communicate with the vehicle through an access point at each wheel that they have to be "trained" or programmed to communicate with. This is done easily using an inexpensive TPMS Training tool.
When you need this Ford tire relearn tool?
1. New TPMS sensors installed, letting air out or adding air in to the tire couldn’t make the system recognize new sensors.
2. Do tire rotation, didn’t have a quick and easy way to let ECU relearn new tire information.
3. When tire pressure indicator light ON, after the maintenance performed, the tire pressure needs to be reset to turn off the TPMS light.
4. Low tire pressure or leakage /replacement or installation of tire pressure monitoring equipment / tire replacement, sensor damage, etc. After those problems solved, TPMS needs to be reset.
5. Exchanging the winter tires or Summer tires.
Applicable Models:
2007-2020 Ford F-150, Mustang, Edge;
2006-2020 Ford Escape, Explorer;
2008-2020 Ford F-250 F-350 F-450 F-550 Super Duty;
2008-2020 Ford Expedition;
2008-2020 Ford Flex;
2008-2020 Ford E-150 E-250 E-350 E-450 Econoline Vans;
2008-2016 Ford Fiesta;
2007-2020 Ford Focus,Fusion;
2008-2020 Ford Crown Victoria;
2011-2020 Ford Transit Connect;
2008-2020 Ford Taurus;
2014-2020 Ford Transit;
2006-2020 Ford Ranger;
2012-2020 Ford C-Max;
2007-2020 Lincoln MKX, MKT;
2008-2020 Lincoln MKZ, MKS, Navigator;
2008-2011 Lincoln Town Car;
2007-2010 Lincoln Mark LT;
2015-2020 Lincoln MKC;
2006-2010 Mercury Mountaineer;
2006-2020 Monterey;
2006-2011 Mercury Mariner;
2007-2011 Mercury Mlian;
2006-2010 Mercury Grand Marquis; and more...
Tips for tpms tool:
[1] Please make sure antenna fit in CORRECT position.
[2] Do tire reset outside instead of in the garage.
[3] Position of tires is also important, Front tires have to be straight
[4] Sensors should be original OEM sensors which well programmed.
[5] After testing a tire, turn device off & press the launch button again to activate the next one.
How to set Ford vehicle in TPMS re-learn mode?
1. Make the gear in P position.
2. Ignition switch to OFF, press and release the brake pedal.
3. Turn ignition switch from OFF position to RUN position
3 times
and end at RUN position.
4. Depress and release the brake pedal.
5. Ignition to OFF position.
6. Ignition goes from OFF position to RUN position
3 times
and ends at RUN position.
7. Horn will ring once and TPMS indicator flashes, then learning mode has been entered successfully. If equipped, the message center will display the front left (LF) tire.
How to Train Tire Pressure Monitior Sensors TPMS?
1. Turn the ignition switch to the OFF position, then press and release the brake pedal.
2. Cycle the ignition switch from the OFF position to the RUN position 3 times, ending in the RUN position.
3. Press and release the brake pedal.
4. Turn the ignition switch to the OFF position.
5. Turn the ignition switch from the OFF position to the RUN position 3 times, ending in the RUN position.
*The horn will sound once and the TPMS indicator will flash if the training mode has been entered successfully. If equipped, the message center will display TRAIN LF TIRE.*
6. Place the tire pressure monitor activation tool on the LEFT (Driver\'s Side) FRONT tire sidewall at the valve stem.
Press and release the test button repeatedly on the TPMS Tool until the horn beeps.
(It may take up to 6 seconds for the tool to activate the sensor, Leave the tool on the sidewall for the entire 6 seconds).
The horn beeping indicates that the body control module has recognized the TPMS sensor.
7. Within 2 minutes of the horn sounding confirming programming of the LF tire, place the TPMS tool on the RIGHT (Passenger\'s Side) FRONT tire sidewall at the valve stem and press the test button to activate the sensor
8. Repeat step 7 for RIGHT REAR followed by LEFT REAR tire in that order. The procedure is complete after the last tire has been trained。
When training is complete, the message center (if equipped) will display TIRE TRAINING COMPLETE. For vehicles not equipped with a message center, successful completion of the training procedure is verified by turning the key to the OFF position without the horn sounding. If the horn beeps twice when the switch is turned to OFF the training procedure was not successful.
How to Use?
1) The use angle of TPMS19 is 180° or 90° right angle with the gas nozzle.
2) Please make sure TPMS19 in correct position when using it.
NOTE 1:
If the vehicle or wheels/sensors have been stationary for more than 30 minutes, the sensors will go into a "sleep mode" to conserve battery power. It is necessary to wake them up by simply moving them or rolling the tires before they will communicate with the vehicle.
NOTE 2:
The TPMS training procedure must be done on one vehicle at a time, in an area without radio frequency interference - at least 3 feet away from other vehicles equipped with TPMS sensors.
NOTE 3:
Vehicles with different tire pressures front-rear like F-Series trucks and E-Series vans also require TPMS re-training after a tire rotation. Failure to train the sensors will cause the TPMS warning light to illuminate on the dash.
Packing List:
1pc * TPMS Reset Tool
Payment
Shipping details
Returns
Contact us
OEM/Customize
Payment
We can
ONLY
accept Paypal Payment, and ONLY ship package to Paypal Address.
Shipping details
1. The item will be shipped out via DHL/EMS/FEDEX/UPS/China Post/UPS( Please leave us your phone NO. for fast delivery and value for custom clearance)
2. We will ship your order within 48 hours upon Receiving Cleared Payment except Weekend and Public Holidays.
3. Turkey, Brazil, Saudi Arabia, Russian, Greek, Belarus, Ukraine, Romonia these countries we only offer EMS/Aramex or China Post service.
4. It will take 3-7 working days via DHL/FEDEX/UPS/ARAMEX, 10-25 business days via EMS, 10-90 working days via China post/other Post Office.
If your place is a remote area on DHL / UPS Extended Area Surcharge (EAS) Definitions, you may have to pay additional 36USD as Remote surcharge, that is not included in Shipping fee or Price.
Recently the Post announced that all items shipping by air are now subject to x-ray screening for regulated materials. This additional screening has cause delay in shipment. Please be aware that delivery may take a few days longer than usual. Your patience is greatly appreciated.
Returns
1. For any exchange or refund, we need the original receipt or a record of the purchase in our system, and the product must be in its original condition, including the box, packaging, and all the accessories.
2. Buyers should pay for the returning shipping fee.
3. If you have any questions or problems for the goods,contact with us first before you take other actions, We will really appreciate of your kindness to give us the opportunity to resolve a problem.
Contact us
Our customer service team works Monday to Friday from 9am to 6pm GMP+8.
Please always talk to us via eBay email system.
OEM/Customize
If you want OEM or order more from our store , if you want to customize some features, you can contact with me , i'll give you a best price or plan.
Look forward to our cooperation.